We also offer a full 'HAT'sized version for Pi A +, B +, Pi 2 & 3.įritzing Object available in the Adafruit Fritzing Library This bonnet is designed for use with Raspberry Pi Zero but you can put on top of any Raspberry Pi with a 2 × 20 connector, it will just not stick out as far. You can also swap out the 2 × 20 header with a slim 2 × 20 type if you want it to sit closer to the Pi, or an extra tall one if you want it to sit above the USB / Ethernet ports.Ī bit of light soldering is required to attach the header to the PCB but it's easy work. You can customize your Perma-Proto setup using a standard 2 × 20 stacking header or extra tall 2 × 20 stacking header.
Unlike our Perma-Proto HATs, this design does not include an EEPROM, so you can 'stack' it with other Bonnets and pHATs without worrying about an EEPROM address collision. The Perma-Proto Bonnet comes with a printed circuit board and a single 2 × 20 GPIO Header for Raspberry Pi to put your Perma-Proto on top of your Raspberry Pi Zero (like a nice little bonnet…). Near the top we break out nearly every pin you could want to connect to the Pi (# 26 didn't quite make the cut). There's also long power strips for + 3V, + 5V and Ground connections to the Pi. The holes are connected underneath with traces to mimic the solderless breadboards with which you're familiar. It has a grid of 0.1 ″ prototyping soldering holes for attaching chips, resistors, LED, potentiometers and more. To add to the Adafruit Bonnet party, we have this Perma-Proto inspired plug in daughter board. Design your own Bonnet or pHAT, attach custom circuitry and otherwise dress your Pi Zero with this jaunty prototyping Bonnet kit!
0 kommentar(er)
